Filtyp
We will present the formation of nanoparticle chains by deposit magnetic iron oxide aerosol nanoparticles in a combined electric and magnetic field. Aerosol methods, in particular spark ablation, provides a good means to produce magnetic nanoparticles with a controllable size and concentration in a broad size range without agglomeration. These aerosol nanoparticles are usually deposited using an e
Magnetic nanoparticles have shown great potential for use in drug delivery and bioimaging applications and are prospective building blocks in future high-performing permanent magnets. Today, magnetic nanoparticles are most often produced in batches by chemical methods resulting in the risk of chemical impurities and production of vast amounts of chemical waste. Aerosol generation methods on the ot
Nanoparticle superlattices consisting of densely packed particles with periodic arrangements can exhibit interesting collective properties different from those of individual nanoparticles and thus have attracted great interest in research due to their potential applications in optoelectronic, plasmonic, and magnetic devices. Evaporation-induced self-assembly on solid substrates which employs nanop
Nanoparticle superlattices consisting of densely packed particles with periodic arrangements can exhibit interesting collective properties different from those of individual nanoparticles and thus have attracted great interest in research due to their potential applications in optoelectronic, plasmonic, and magnetic devices[1, 2]. Evaporation-induced self-assembly on solid substrates which employs
In this paper an acoustofluidic system to trap hydrogel droplets is shown. The presented trapping method is label-free, biocompatible and operated in non-contact mode. The results show that the droplets can be trapped at flow rates up to 76 μL/min which corresponds to an average flow speed of 3.2 mm/s. Moreover, it is shown that the droplets can be trapped for several hours, thus allowing for stud
To investigate the relation between joint involvement in the upper extremities and grip force in patients with early rheumatoid arthritis (RA). An inception cohort of 225 patients with early RA was followed according to a structured protocol. The same rheumatologist assessed all patients for swollen joints and joint tenderness. Grip force was measured (Grippit; AB Detektor, Gothenburg, Sweden) at
It has been shown that long-range p-wave superconductivity in a Kitaev chain can be engineered via an ac field with a high frequency [M. Benito, Phys. Rev. B 90, 205127 (2014)PRBMDO1098-012110.1103/PhysRevB.90.205127]. For its experimental realization, however, theoretical understanding of Floquet engineering with a broader range of driving frequencies becomes important. In this paper, focusing on
Using Deterministic Lateral Displacement devices optimized for sensitivity to particle length, we separate subpopulations of bacteria depending on known properties that affect their capability to cause disease (virulence). For the human bacterial pathogen Streptococcus pneumoniae, bacterial chain length and the presence of a capsule are known virulence factors contributing to its ability to cause
Background: In patients with systemic lupus erythematosus (SLE) there is no serological test that will reliably distinguish neuropsychiatric (NP) events due to active SLE from those due to other causes. Previously we showed that serum levels of nitrated nucleosomes (NN) were elevated in a small number of patients with NPSLE. Here we measured serum NN in samples from a larger population of patients
The photothermoelectric (PTE) effect uses nonuniform absorption of light to produce a voltage via the Seebeck effect and is of interest for optical sensing and solar-to-electric energy conversion. However, the utility of PTE devices reported to date has been limited by the need to use a tightly focused laser spot to achieve the required, nonuniform illumination and by their dependence upon the See
Germanium solar cells are used as bottom subcells in many multijunction solar cell designs. The question remains whether the thermal load originated by the growth of the upper layers of the multijunction solar cell structure affects the Ge subcell performance. Here, we report and analyze the performance degradation of the Ge subcell due to such thermal load in lattice-matched GaInP/Ga(In)As/Ge tri
Semiconductor nanowire arrays are a promising candidate for next generation solar cells due to enhanced absorption and reduced material consumption. However, to optimize their performance, time consuming three-dimensional (3D) opto-electronics modeling is usually performed. Here, we develop an accurate one-dimensional (1D) modeling method for the analysis. The 1D modeling is about 400 times faster
Objective: To determine the level of agreement of disease flare severity (distinguishing severe, moderate, and mild flare and persistent disease activity) in a large paper-patient exercise involving 988 individual cases of systemic lupus erythematosus. Methods: A total of 988 individual lupus case histories were assessed by 3 individual physicians. Complete agreement about the degree of flare (or
Background/objectives: Studies on the health effects of whole grains typically use self-reported intakes which are prone to large measurement errors. Dietary biomarkers that can provide an objective measure of intake are needed. New alkylresorcinol (AR) metabolites (3,5-dihydroxycinnamic acid (DHCA), 2-(3,5-dihydroxybenzamido)acetic acid (DHBA-glycine) and 5-(3,5-dihydroxyphenyl) pentanoic acid (D
Realizing visionary concepts of integrated photonic circuits, nanospectroscopy, and nanosensing will tremendously benefit from dynamically tunable coherent light sources with lateral dimensions on the subwavelength scale. Therefore, we demonstrate an individual nanowire laser based device which can be gradually tuned by reversible length changes of the nanowire such that uniaxial tensile stress is
To mitigate dangerous climate change, a transition to a new and sustainable energy system is needed. In this system, solar energy will need to be a key player. Prices of electricity made from solar cells have declined rapidly over the recent decades, making solar energy competitive in more markets. However, further price reductions and new innovations are needed for solar cell technology to fulfil
ConspectusFunctional materials and devices require nanoscale control of morphology, crystal structure, and composition. Vapor-liquid-solid (VLS) crystal growth and its related growth modes enable the synthesis of 1D nanostructures, commonly called "nanowires", where the necessary nanoscale heterogeneity can be encoded axially. During the VLS process, a seed particle collects atoms and directs the
